No hot water from a Worcester combi boiler
If your Worcester combi boiler is firing for heating but not producing hot water (or vice versa), the most common cause is a faulty diverter valve. The diverter valve directs hot water either to the radiators or to the hot water tap — if it sticks or fails, one function stops working.
A faulty diverter valve is a common repair on Worcester Bosch combi boilers and is usually straightforward to replace. David carries Worcester Bosch spare parts and can often carry out the repair on the same visit.
Hot water that runs cold after a few seconds
If your hot water starts warm but quickly runs cold, this is often caused by a phenomenon known as cold water sandwich — a brief burst of cold water between two bursts of hot. This is a characteristic of some combi boilers and is not always a fault.
However, if the water consistently runs cold after a short time, the cause may be a failing heat exchanger, a blocked filter, or low gas pressure. These require investigation by a qualified engineer.
Error codes on Worcester boilers
Worcester Bosch boilers display fault codes when they lock out. Common codes include EA (ignition fault), A1 (low water pressure), and D5 (fan fault). If your boiler is displaying a fault code, note it down and call David — he can often diagnose the fault over the phone before visiting.
When to call an engineer
If your Worcester boiler has stopped producing hot water and a simple reset has not resolved it, call David on 0772 286 6616. As a Worcester Bosch Accredited Installer, he has the training and parts to diagnose and repair Worcester Bosch boilers efficiently.
Need help with your heating?
Call Dave for honest, professional advice — no obligation, no call centres.